Campbell Residence

Project Overview

EARTHTEK Paving and Grinding Inc completed this residential concrete driveway replacement in Campbell, CA, transforming an aging driveway into a clean, reinforced concrete surface built to serve the home for decades. Our crew removed the old surface, installed wire mesh reinforcement, and placed pumped concrete finished with tooled control joints and a smooth, uniform surface from the street to the garage.

This project came with a logistical challenge common on residential streets: limited access for heavy trucks. Rather than driving a loaded mixer across the property, our crew staged the mixer and concrete pump at the street and pumped the mix directly to the driveway — protecting the sidewalk, landscaping, and sub-base while keeping the pour continuous for a consistent, high-quality finish.

Scope of Work

• Removal of the existing driveway surface
• Base preparation and forming
• Wire mesh reinforcement installation
• Pumped concrete placement and finishing
• Control jointing and curing

Why This Project Was Needed

Aging driveways in Campbell and the South Bay typically show a familiar set of problems before replacement becomes the right call:

• Widespread cracking — once cracks spread across multiple slabs, patching becomes a losing battle
• Settling and uneven sections — sunken slabs create trip hazards and pooling water
• Surface wear and spalling — a deteriorated finish that no longer protects the slab beneath
• Drainage problems — an old, improperly sloped surface can push water toward the garage or foundation
• Curb appeal — a cracked, stained driveway drags down the look of the entire property
• Access constraints — tight residential streets require a contractor equipped to pump concrete rather than drive heavy trucks over sidewalks and landscaping

Our Concrete Driveway Process on This Project

• Demolition & removal — Removed the existing driveway surface and hauled material away for recycling.
• Base preparation — Graded and compacted the sub-base for uniform support, with drainage accounted for along the full run.
• Forming — Set forms to match the garage apron, sidewalk, and street connection for flush, seamless transitions.
• Wire mesh reinforcement — Installed welded wire mesh across the slab area to control cracking and tie the pour together structurally.
• Pumped concrete placement — Staged the mixer and pump truck at the street and pumped concrete directly to the forms — a continuous pour with no truck traffic over the sidewalk or prepared base.
• Screeding & finishing — Screeded to grade, floated, and finished the surface to a clean, uniform texture.
• Control jointing — Tooled control joints at proper spacing so future movement happens at planned lines, not random cracks.
• Curing & protection — Coned off the fresh pour and allowed proper cure time — foot traffic after 24–48 hours, vehicles after 7 days.

Equipment Used on This Project

• Concrete pump truck with placement hose
• Ready-mix concrete truck
• Skid steer for demolition and base work
• Plate compactor for base preparation
• Forms, screeds, bull floats, and finishing tools
• Edgers and jointing/grooving tools
• Traffic cones and site protection

The Result

A brand-new reinforced concrete driveway with a smooth, uniform finish, clean control joints, and seamless transitions at the sidewalk and garage — completed without damage to the surrounding landscaping or sidewalk, and built to handle daily use for decades with minimal maintenance.

Need Concrete Driveway Work in Campbell or the South Bay?

From full driveway replacement to targeted concrete repair, EARTHTEK Paving and Grinding Inc delivers reinforced, properly finished concrete work — including pumped placement for properties with tight access. Contact us today for a free driveway estimate.